E.5: Resetting The Iec 61850 Protocol Ethernet Network Card - Electro Industries Shark 200 Installation & Operation Manual

E.5: Resetting the IEC 61850 Protocol Ethernet Network Card

If you need to reset the IEC 61850 Protocol Ethernet Network card, you can use the
Reset Network Card webpage.
1. Click Reset Network Card from the bottom of the Information webpage.
2. You will see a screen similar to the one shown above. Enter the Reset Password:
the default is adminR35et for firmware runtime version 3.35 or later; and
r2d2andc3po for earlier firmware runtime versions. See the note on page A-21.
3. Click the Reset button. The Network card will reset.
NOTE: As a result of the reset, the communication link with the card will be lost
and must be re-established.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
E: Using the IEC61850 Network Card
#
Doc E149701 E-28