Table of Contents
Advertisement
3. When active, the Push Client State button says Enabled. If the button says Dis-
abled, click on it to change it to Enabled. Note that when the client is disabled, it is
in a suspended mode (no data is being pushed), but settings can still be changed.
4. Enter:
• The url of the server: this is the address the Lucid client will connect to. It can be
either a url or an IP address. This information will be supplied to the customer
by Lucid. Note that Lucid Push in the INP100S implements "http" protocol, not
"https": if the supplied address uses "https," contact Lucid for instructions on
accessing the http only server.
• The server port: this is the TCP/IP port the Lucid client connects to - this is
usually 80.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
8: Using the INP100S Network Card
Click to Enable/Disable
Enter server url
#
Doc
E149701
8-21
- Quick Links:
- Communication Installation
Hide quick links:
Advertisement
Table of Contents
