Performing Network Configuration; Upgrading The Ethernet Card's Firmware - Electro Industries Shark 200 Installation & Operation Manual

8.3: Performing Network Configuration

As with the other Option cards, the Shark ® 200 meter auto-detects the presence of an installed Ethernet card.
Configure the Ethernet card through Communicator EXT. Refer to Chapter 5 of the Communicator EXT User's
Manual for instructions.

8.4: Upgrading the Ethernet Card's Firmware

Follow this procedure to upgrade the Ethernet card's firmware.
1. From Communicator EXT's Main screen, click
Tools>Flash Network Card. You will see the screen
shown on the right.
2. Follow this procedure:
a. Enter the upgrade filename or click Select to browse
for it.
b. Enter Network card Username and Password;
e.g. "eignet" and "inp200."
c. Press Start.
3. Check the firmware version by clicking Get
Firmware Info.
4. Once you have confirmed that the firmware
version is correct, click Reset Device.
5. Click Close to return to the Communicator EXT
Main screen.
e
Electro Industries/Gauge Tech
Doc# E149701
8-2