Electro Industries Shark 200 Installation & Operation Manual page 107

Use the entry fields to set the start and end times for the Daylight Savings Time
feature, if enabled. Select the values you want from the Month, Week, Day of the
Week, and Hour fields.
NOTE: The Hour field uses a 24-Hour clock.
The other fields on the screen are used to set up clock synchronization for the meter.
There are two available clock synchronization methods:
1. If your meter has the Network Option card, you can use the card to access a Net-
work Time Protocol (NTP) Server for clock synchronization.
2. You can use line frequency synchronization (Line Sync) for clock synchronization.
Line Sync synchronizes the clock to the AC frequency. This a very common syn-
chronizing method.
Use these fields to set up NTP clock synchronization:
1. Time Zone: Zone Descriptor - Select the hour and minute of your time zone in
relation to Greenwich Mean Time. For example, if your time zone is Eastern Stan-
dard time, you would select -5 from the pull-down Hour menu and leave the Min-
utes field at 0.
2. Under Clock Sync select:
• Yes from the Enable pull-down menu
• NTP from the Method pull-down menu
• The location of the Network Option card - select either Option Card in Slot 1 or
Option Card in Slot 2 from the Interface pull-down menu.
NOTE: You also need to set up the NTP server information when you configure the
Network card's settings. See Chapter 8 of the Communicator EXT
instructions.
Use these fields to set up Line Frequency clock synchronization:
Under Clock Sync select:
• Yes from the Enable pull-down menu
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
5: Communication Installation
#
Doc E149701
TM
User Manual for
5-27