Network Time Protocol (Ntp) Server - Electro Industries Shark 200 Installation & Operation Manual

• Network Time Protocol (NTP) server: the url of the NTP server, if one is being
used for time synchronization.
NOTES:
• The IEC 61850 Protocol Ethernet Network card needs time information to
work properly. The time can be provided either by a Network Time Proto-
col (NTP) server or by the Shark 200® meter itself (via Line Sync, which
is selected and enabled through the Time Settings screen). If you enter
an NTP server on this screen, you still need to enable it in the Time Set-
tings screen (see the instructions in Chapter 5: Communication Installa-
tion on page 5-1). See 8.4.3: NTP Time Server Synchronization on
page 8-24, for additional information on NTP.
• All of these parameters must be properly set up in order to allow the
Shark® 200 meter to communicate on the network. After configuration, a
simple "ping" test can be performed to see if the Shark® 200 meter is
correctly connected to the network:
a. From the Start menu, type run and press Enter.
b. In the Run window, type cmd and click OK.
c. In the command window type ping Network Card's IP address.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
See the example screen below.
E: Using the IEC61850 Network Card
#
Doc E149701 E-19