Using The Front Panel; Understanding Startup And Default Displays - Electro Industries Shark 200 Installation & Operation Manual

6.2: Using the Front Panel

You can access four modes using the Shark® 200 meter's front panel buttons:
• Operating mode (Default)
• Reset mode
• Configuration mode
• Information mode - Information mode displays a sequence of screens that show
model information, such as Frequency, Amps, V-Switch, etc.
Use the Menu, Enter, Down and Right buttons to navigate through each mode and
its related screens.
NOTES:
• See Appendix A: Shark® 200 Meter Navigation Maps on page A-1, for the display's
Navigation maps.
• The meter can also be configured using software; see Chapter 5: Communication
Installation on page 5-1 and the Communicator EXT
Software User Manual for instructions.

6.2.1: Understanding Startup and Default Displays

Upon powering up, the meter displays a sequence of screens:
• Lamp Test screen where all LEDs are lit
• Lamp Test screen where all digits are lit
• Firmware screen showing the build number
• Error screen (if an error exists)
After startup, if auto-scrolling is enabled, the Shark® 200 meter scrolls the parameter
readings on the right side of the front panel. The Kilo or Mega LED lights, showing the
scale for the Wh, VARh and VAh readings. Figure 6.3 shows an example of a Wh
reading.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
6: Using the Shark® 200 Meter
TM
4.0 and MeterManager EXT
#
Doc E149701 6-3