E.4: Upgrading The Iec 61850 Protocol Ethernet Network Card's Firmware - Electro Industries Shark 200 Installation & Operation Manual

E.4: Upgrading the IEC 61850 Protocol Ethernet Network Card's
Firmware
To upgrade the IEC 61850 Protocol Ethernet Network card's firmware, click Upgrade
Firmware from the bottom of the Information webpage.
You will see a screen similar to the one shown above.
1. Click the Browse button to locate the Upgrade file. Make sure that you select the
INP300S option card upgrade file. If you upgrade with the INP100S upgrade file,
the card will work, but most IEC 61850 features will be disabled. In that case,
perform the upgrade again, using the correct INP300S upgrade file.
2. Enter the Safety Code.
3. Enter the Upgrade Password: the default is n3tUp!0Ad for firmware runtime version
3.35 and later; and eignet2009 for earlier firmware runtime versions. See the note
on page E-22.
4. Click Submit. Be sure to keep the meter powered during the firmware upgrade.
After the upgrade process is complete, the Network card will reset.
NOTE: As a result of the reset, the communication link with the card will be lost
and must be re-established.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
E: Using the IEC61850 Network Card
#
Doc E149701 E-27