Resetting The Ethernet Card - Electro Industries Shark 200 Installation & Operation Manual

8.4.2.2: Resetting the Ethernet Card

From one of the Shark® 200 meter's webpages:
1. Click Information on the left side of the webpage.
2. Click Reset Network Card (bottom box on the right). You will see the webpage
shown below.
3. Enter the Reset password: the default is adminR35et for firmware runtime version
3.35 or later; and r2d2andc3po for earlier firmware runtime versions. See the note
on page 8-9.
4. Click Reset.
NOTE: As a result of the reset, the communication link with the card will be lost
and must be re-established.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
8: Using the INP100S Network Card
#
Doc E149701 8-13