Key Technology; Obtaining A V-Switch Key - Electro Industries Shark 200 Installation & Operation Manual

2.1.3: V-Switch
TM
The Shark® 200 meter is equipped with V-Switch
firmware-based switch that lets you enable meter features through software
communication. V-Switch
without removal from service.
Available V-Switch
• V-Switch™ key 1 (V-1): Multifunction measurement
• V-Switch™ key 2 (V-2): Multifunction measurement and 2 MegaBytes* for data
logging
• V-Switch™ key 3 (V-3): Multifunction measurement with harmonics and 2 Mega-
Bytes* for data logging
• V-Switch™ key 4 (V-4): Multifunction measurement with harmonics, 2 MegaBytes*
for data logging, and limit and control functions
• V-Switch™ key 5 (V-5): Multifunction measurement with harmonics, 3 MegaBytes*
for data logging, limit and control functions, and 64 samples per cycle waveform
recorder
• V-Switch™ key 6 (V-6): Multifunction measurement with harmonics, 4 MegaBytes*
for data logging, limit and control functions, and 512 samples per cycle waveform
recorder
*Because the memory is flash-based rather than NVRAM (non-volatile random-access
memory), some sectors are reserved for overhead, erase procedures, and spare sec-
tors for long-term wear reduction.
Obtaining a V-Switch
Contact EIG's inside sales staff at sales@electroind.com or by calling (516) 334-0870
(USA) and provide the following information:
1. Serial number(s) of the meter(s) you are upgrading. Use the number(s), with lead-
ing zeros, shown in the Communicator EXT
Communicator EXT
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions

Key Technology

TM
key technology allows meter upgrades after installation
TM
key upgrades are as follows:
TM
Key:
TM
Main screen, click Tools>Device Status).
2: Meter Overview and Specifications
TM
key technology, a virtual
TM
Device Status screen (from the
#
Doc E149701 2-8