Electro Industries Shark 200 Installation & Operation Manual page 336

You will need the following information:
• The IP address to be assigned to the card.
• The Network Mask used on your network.
• The IP address of the Gateway on your network (you can use 0.0.0.0 if you don't
have a gateway IP address).
• The IP address of the DNS (Domain Name Server) on your network (only needed if
you plan to use URLs instead of IP addresses for the NTP (Network Time Protocol);
if not needed you can leave this field blank).
• The IP address of the NTP server on your network, or the URL if you configured the
DNS in the previous entry field.
NOTE: The network card supports NTP version 4.0 client/server mode up to Net-
work card firmware version 3.44. Starting in version 3.45, the network card works
with NTP version 3.0 or 4.0 (autodetect) in client/server mode. Broadcast is not
supported in any version.
1. Using Communicator EXT™ software, connect to the meter through its RS485 serial
port, or through an INP100S Network Card if one is installed in the other Option
card slot (see Chapter 5: Communication Installation on page 5-1, for instructions
on connecting to your meter with Communicator EXT™ software).
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
E: Using the IEC61850 Network Card
#
Doc E149701 E-16