Table of Contents
Advertisement
5.1.4: Ethernet Connection
In order to use the Shark® 100S submeter's Ethernet capability, the Ethernet
Module must be installed in your meter, and the JP2 must be set to positions 2-3. You
can use either wired Ethernet, or WiFi.
For wired Ethernet, use Standard RJ45 10/100BaseT cable to connect to the Shark®
100S submeter. The RJ45 line is inserted into the RJ45 port of the meter.
For Wi-Fi connections, make sure you have the correct antenna attached to the meter.
Wireless Ethernet Connection
Ia Ia Ib Ib Ic Ic
(+) (-) (+) (-) (+) (-)
Refer to Chapter 6 for instructions on how to set up the Network Module.
** See the JP2 figure and instructions on page 5-4.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
Electronic Circuits
Z K Y + - SH
Va Vb Vc Vn L1 L2 PE
5: Communication Installation
Ethernet Module
JP2: Must be in
position 2-3 for
Ethernet (RJ45 or WiFi)
RS-485
Doc
E145721
#
**
To Other
Devices
5 - 6
Advertisement
Table of Contents
