Detail Of Guide Track; Using The I/O Option Cards - Electro Industries Shark 200 Installation & Operation Manual

7.2: Installing Option Cards
The Option cards are inserted in one of the two Option Card slots in the back of the
Shark® 200 meter.
NOTE: Remove Voltage inputs and power supply terminal to the meter before
performing card installation.
1. Remove the screws at the top and the bottom of the Option Card slot covers.
2. There is a plastic "track" on the top and the bottom of the slot. The Option card fits
into this track.
For safety, remove ALL these connections before installing Option
cards: GND, L+, L-, Vref, Va, Vb, Vc.
3. Slide the card inside the plastic track and insert it into the slot. You will hear a click
when the card is fully inserted. Be careful, it is easy to miss the guide track.
4. Securely re-fasten the screws at the top and bottom of the card.
CAUTIONS!
• Make sure the I/O card is inserted properly into the track to avoid damaging the
card's components.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions

7: Using the I/O Option Cards

Figure 7.2: Detail of Guide Track
#
Doc E149701 7-2