To Use The E205301; Meter Hookup; And Programming Overview - Electro Industries Shark 200 Installation & Operation Manual

To use the E205301:

1. Download the E205301 driver from the EIG website: www.electroind.com/USB485-
cable.html.
2. Connect the RS485 side of the cable to the meter's RS485 port, as shown in the fig-
ure, below.
3. Connect the USB connector to your device's USB port.
4. Follow the programming instructions in Section 5.2.2.
5.2: Shark® 200T Transducer Communication and Programming
Overview
The Shark® 200T transducer does not include a display on the front face of the
meter; there are no buttons or IrDA Port on the face of the meter. Programming and
communication utilize the RS485 connection on the back of the meter as shown in
Figure 5.1. Once a connection is established, Communicator EXT
used to program the meter and communicate to Shark® 200T transducer slave
devices.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
5: Communication Installation
#
Doc E149701
TM
software can be
5-7