Electro Industries Shark 200 Installation & Operation Manual page 166

a. You select an event by clicking on the button next to it:
• To select a condition that will cause a Notification email to be sent, click
once on the button next to the condition. The button will turn black.
• To select a condition that will cause an Alarm email to be sent, click twice
on the button next to the condition. The button will turn red.
• Note that when you designate a condition as an alarm, an alarm
• There are some conditions which cannot be set as alarms, but only
• To de-select a condition, click on the button until it is empty, again - not
black or red.
b. You can select multiple conditions for alarms and notifications. When you are
done, click the Next button.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
email will be sent out within a minute after the condition occurs and a
notification email will also be sent out at the next notification period.
If you have not set up any notification emails, then only the alarm
email will be sent.
as notifications. These conditions are Programmable Settings
Change, V-Switch Changed, and Unit Start Up.
8: Using the INP100S Network Card
#
Doc E149701 8-16