Configuring Option Cards; 1Ma Output Card - Electro Industries Shark 200 Installation & Operation Manual

7.3: Configuring Option Cards

CAUTION! FOR PROPER OPERATION, RESET ALL PARAMETERS IN THE UNIT
AFTER HARDWARE MODIFICATION.
The Shark® 200 meter auto-detects any Option cards installed in it. You configure the
Option cards through Communicator EXT
Communicator EXT
instructions.
The following sections describe the available Option cards.
7.4: 1mA Output Card (1mAOS)
The 1mA card transmits a standardized bi-directional 0-1mA signal. This signal is
linearly proportional to real-time quantities measured by the Shark® 200 meter. The
outputs are electrically isolated from the main unit.
7.4.1: Specifications:
The technical specifications at 25 °C at 5 k load are as follows:
Number of outputs:
Power consumption:
Signal output range:
Max. load impedance:
Hardware resolution:
Effective resolution:
Update rate per channel:
Output accuracy:
Load regulation
Temperature coefficient
Isolation:
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
TM
4.0 and MeterManager EXT Software User Manual for detailed
4 single ended
1.2 W internal
(-1.2 to +1.2) mA
10 k
12 bits
14 bits with 2.5 kHz PWM
100 ms
± 0.1 % of output range (2.4 mA)
± 0.06 % of output range (2.4 mA) load step of 5
k @ ± 1mA
± 30 nA/ °C
AC 2500 V system to outputs
7: Using the I/O Option Cards
TM
software. Refer to Chapter 8 of the

#
Doc E149701 7-4