Download  Print this page


9. Using Menu Functions
[Metering Mode]
Applicable modes:
Type of optical measurement to measure brightness can be changed.
[Rec] > [Metering Mode]
(Centre weighted)

[Highlight Shadow]

Applicable modes:
You can adjust the brightness of bright and dark portions on an image while checking the
brightness on the screen.
[Rec] > [Highlight Shadow]
(Raise the contrast)
(Lower the contrast)
(Brighten dark areas)
Rotate the front/rear dial to adjust the brightness of
bright/dark portions.
A Bright portion
B Dark portion
• Adjustments can also be made by dragging the graph.
• To register a preferred setting, press 3, and select the
destination where the custom setting will be registered to
([Custom1] (
Press [MENU/SET].
This is the method in which the camera measures the most suitable
exposure by judging the allocation of brightness on the whole screen
Usually, we recommend using this method.
This is the method used to focus on the subject on the centre of the
screen and measure the whole screen evenly.
This is the method to measure the subject in the spot
metering target A.
• If you set the spot metering target on the edge of the
screen, the metering may be affected by the brightness
around the location.
A state with no adjustments is set.
Bright areas are brightened, and dark areas are darkened.
Bright areas are darkened, and dark areas are brightened.
Dark areas are brightened.
Registered custom settings can be applied.
)/[Custom2] (
)/[Custom3] (


Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: