Taking Pictures Using Burst Mode - Panasonic Lumix DC-G9 Operating Instructions For Advanced Features

5. 6K/4K Photo and Drive Settings

Taking Pictures using Burst Mode

Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
• You can apply different Burst Mode settings to [
setting [Burst Shot 1 Setting] and [Burst Shot 2 Setting] in the [Rec] menu.
1
Set the drive mode dial to [
1) or [ ] (Burst Shot 2).
2
Select the Burst Mode setting.
>
MENU
[Burst Shot 2 Setting]
[SH2]
Performs super high-speed burst recording with the electronic shutter.
• The burst speed will be faster with [SH2] than with [SH1].
[SH1]
Performs super high-speed burst recording with the electronic shutter.
[SH2 PRE]
Pictures taken at the moment before the shutter button is pressed fully (a
maximum of 0.4 seconds) will be saved in addition to those taken after it is
pressed fully.
[SH1 PRE]
• The burst speed will be faster with [SH2 PRE] than with [SH1 PRE].
[H] Performs high-speed burst recording.
[M] Performs medium-speed burst recording.
[L] Performs low-speed burst recording.
3
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
• When [SH2] or [SH1] has been selected: If you press the
shutter button halfway first and then press it fully, you can
perform recording without a delay that occurs after it is pressed fully.
• When [SH2 PRE] or [SH1 PRE] has been selected:
1 Press the shutter button halfway.
2 Press and hold the shutter button fully.
• Recording starts when the shutter button is pressed halfway. [
recording screen.
• If approx. 1 minute elapses while the shutter button is pressed and held halfway,
press it halfway again.
When approx. 1 minute elapses while the shutter button is pressed and held halfway,
the camera will not be able to save pictures taken before the shutter button is pressed
fully.
[Rec] > [Burst Shot 1 Setting]/
] (Burst Shot 1) and [
] (Burst Shot
115
] (Burst Shot 2) by
4:3
AFS AFS
L
H
] is displayed on the