Panasonic Lumix DC-G9 Operating Instructions For Advanced Features page 325

12. Others
The subject appears distorted on the picture.
• If you record a moving subject when using the electronic shutter or recording motion picture or
a 6K/4K photo, the subject may appear distorted on the picture. This is characteristic of MOS
sensors which serve as the camera's pickup sensors. This is not a malfunction.
Striping or flicker may appear under lighting such as fluorescent lighting and
LED lighting fixture.
• This is characteristic of MOS sensors which serve as the camera's
pickup sensors.
This is not a malfunction.
• When using the electronic shutter (P199), lowering the shutter speed
may reduce the effect of the horizontal stripes.
• If noticeable flicker or striping is seen under lighting such as a
fluorescent or LED lighting fixture when recording motion pictures, set [Flkr Decrease] (P203).
It can reduce the flicker or striping by allowing you to set a fixed shutter speed.
You can set the shutter speed manually in the Creative Video Mode.
Stripes appear in high ISO sensitivity.
• Stripes may appear in high ISO sensitivity or depending on the lens you use.
> Decrease the ISO sensitivity.
The brightness or the hue of the recorded picture is different from the actual
scene.
• When recording under fluorescent or LED lighting fixture, etc., increasing the shutter speed
may introduce slight changes to brightness and colour. These are a result of the characteristics
of the light source and do not indicate a malfunction.
• When recording subjects in extremely bright locations or recording under fluorescent lighting,
LED lighting fixture, mercury lamp, sodium lighting, etc., the colours and screen brightness may
change or horizontal striping may appear on the screen.
Bright spot not in subject is recorded.
• There may be defective pixels in the image sensor.
> Perform [Pixel Refresh] (P231).
Cannot set [Silent Mode] to [OFF].
• At the time of purchase, [Silent Mode] is assigned to the function lever. If the function lever is
set to [MODE2], change the setting to [MODE1].
(P109)
(P48)
325
(P171)