Configure Routed Head Quarter - Nortel CS 1000 Manual

an IP DECT Network in which seamless handover is possible. Use
G.711, which covers the network segments connected using routers
that support IP multicast.
If there are DAPs outside this aggregated subnet mask, regard the
DAP or DAPs as in a branch office. Note that the IP address of the
PBX is compared with the IP address or addresses of the DAP or
DAPs using this subnet mask. If the IP addresses are in various
subnets according to this mask, the DAP or DAPs are supposed to
be in a branch office. If the IP addresses are in the same aggregated
subnet according to this mask, the system assumes that the IP
addresses are in the same subnet.
The term aggregated means that the subnet consists of smaller
subnets connected over a router, but according to the subnet mask,
all behave as one subnet. This applies to the Routed Head Quarter
network solution without branch offices.
Routed Head Quarter configuration implies that various subnets are
connected through one or more routers. The subnets in the network
are part of one company network.
To create a Routed Head Quarter configuration, you must configure
the network components, such as the switches and the routers, for
VoIP and IP multicast. Also, the network must support IP multicast
between all network components used for the SIP DECT system.
Routed Head Configuration is the same as Simple configuration,
but includes one additional step. For information, see
"Configuring Network Settings" (page
Configure Routed Head Quarter
Choose a system configuration.

Configure Routed Head Quarter.

Procedure 102
Choosing system configuration
Step Action
1 If you were referred to this procedure from
"Configuring System Settings" (page
Open the IP DECT Configurator, and click Modify.
2 Select the SIP DECT system that you are running. Click System
Configuration.
3 Choose Routed Head Quarter Configuration for System
configuration.
4 Enter a Time To Live Value greater than 1 to have the Router
forward multicast packages.
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Routed Head Quarter configuration 183
Procedure 89
163).
Procedure 90
165), skip to step 3.