Nortel CS 1000 Manual page 99

12 Click Apply.
13 Start the DHCP server with Start > All Programs > DAP
controller.
14 Restart the DAPs.
If you are configuring a new system, follow the steps in
Procedure 48 "Configuring SIP Settings" (page 113)
restarting DAP.
Built-in TFTP server
The DAP controller 4 has a built-in TFTP server that runs as a service
under Microsoft Windows. You can use the IP DECT Configurator tool
available with the DAP controller 4 to start or stop the TFTP server
program. You can start or stop the service through the services window in
Microsoft Windows.
Configuration without DHCP or TFTP
ATTENTION
DAP configuration without DHCP or TFTP requires DHCP and TFTP to be
temporarily available to program or reprogram DAPs.
You can perform DAP configuration without DHCP or TFTP only after you install
the IP DECT Configurator. For more information, see
102).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
DAP controller software 99
--End--
"DAP Controller" (page
instead of