Nortel CS 1000 Manual page 97

Built-in DHCP and TFTP servers
The DAP controller software Release 4 has a built-in DHCP and
TFTP server. The built-in DHCP and TFTP servers do not require
manual configuration, because the IP DECT Configurator performs the
configuration.
ATTENTION
You can configure a Built-in DHCP and TFTP server only after you install the IP
DECT Configurator. For more information, see
Built-in DHCP server
The DAP controller software Release 4 has a built-in DHCP server. This
server runs as an application that requires you to log on to Microsoft
Windows. You can use the IP DECT Configurator tool available under
DAP controller 4 to start or stop the DHCP server program.
This DHCP server responds to DHCP requests from DAPs because it
checks on Vendor Class Identification D(ECT) AP 49 from a DAP.
You can configure built-in DHCP server using the Network Settings
window of IP DECT Configurator.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
DAP controller software 97
--End--
"DAP Controller" (page 102).