Branch Office Configuration - Nortel CS 1000 Manual

ATTENTION
When a mailbox is configured for SIP DECT handset in CallPilot, you must enter
MWI DN in the following format:
<AC1+LOC+ subscribed DN on DAP>
OR
<TSC+ subscribed DN on DAP>.
Branch Office configuration
Branch Office Configuration is used for a Large Campus network that is
split into various (geographical) segments (branch offices), so that every
branch office has its own subnet and DAPs can exchange IP multicast
packets only using routers or switches in the subnet of their local branch
office. No IP multicast traffic is allowed between branch offices. In this
configuration each branch office behaves as an isolated part of a larger
SIP DECT system. Branch Office configuration supports seamless
handover within each branch office, but not between sites. Support is
unavailable for roaming between branch offices.
To configure Branch Office, see
with CS 1000 SIP Gateway" (page
section when you require more information about Branch Office
configuration.
Select a Branch Office configuration.
Procedure 79
Selecting a system configuration
Step
1
2
3
Action
Perform one of the following steps:
If you were referred to this section from
"Configuring System Settings" (page
OR
Open the IP DECT Configurator, and click Modify.
Select the SIP DECT system that you are running, and click
System Configuration.
Choose Main Site with Branch Office(s) for System
configuration, as shown in the following figure.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.

Branch Office configuration 143

"Basic (simple) SIP DECT configuration
107). Use the information in this
Procedure 47
113), go to step 3.