Nortel CS 1000 Manual page 181

Step Action
1 Perform one of the following steps:
If you were referred to this section from
"Configuring System Settings" (page
OR
Open the IP DECT Configurator, and click Modify.
2 Select the SIP DECT system that you are running, and click
System Configuration.
3 Choose Main Site with Branch Office(s) for System
configuration, as shown in the following figure.
4 Configure each branch office by entering the following
parameters:
•
Subnet - the first address in the subnet range. For instance,
192.168.32.0.
•
Subnet mask - mask to specify the subnet boundaries.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Branch Office configuration 181
Procedure 90
165), go to step 3.