Pc (Dap Controller); Dect Access Points; Deployment Requirements - Nortel CS 1000 Manual

18 Site planning and hardware deployment
For more information about CS 1000 installation, see Communication
Server 1000E Installation and Commissioning (NN43041-310).

PC (DAP controller)

Minimum specifications for the DAP controller PC are as follows.
•
2.4 GHz CPU
•
512 MB RAM
•
CD-ROM drive
•
1GB free hard disk space

DECT Access Points

Two models of DECT Access Points (DAP) are currently available for
Nortel SIP DECT: C4710 and C4710E. The C4710E is a special version
of the C4710 Access Point that provides an alternative with an external
antenna connection for outdoor use.
•
C4710 DAP
—
—
•
C4710E DAP
—
—
ATTENTION
The only audio codec supported on the C4710 and C4710E DAPs is the G.711
codec. Ensure that the G.711 codec is available in your system.
It is not possible to make calls between the Nortel IP Softphone 2050 and DECT
handsets when you select the I use a modem to connect to the network
check box in the Audio settings for the softphone. If you select this setting, the
Nortel IP Softphone 2050 uses the G.729 codec for all calls.
When using Multimedia PC Client, ensure that you select Medium Speed or
High Speed in the Multimedia PC Client Connection preferences if you plan to
make calls between DECT handsets and Multimedia PC Clients.
Ensure that the DAPs are installed according to the location
recommendations. For more information, see
(page

Deployment requirements

This section describes SIP DECT deployment requirements.
PEC: NTCW26AAE5
CPC: N0162007
PEC: NTCW26BAE5
CPC: N0162008
18).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
"Deployment requirements"