Firewall Protection; Internet Information Services - Nortel CS 1000 Manual

80 Software requirements
If a firewall is installed on your DAP Controller PC, ensure the firewall
does not block the ports used for various services. For information,
see
•
Internet Explorer 6.0 or later
•
Internet Information Services (IIS)
For information about installing IIS, see
(page
•
DHCP and TFTP servers
For information about installing DHCP and TFTP servers, see
and TFTP servers" (page
•
DAP Controller (IP DECT Configurator and DAP Manager)
For information about installing the DAP Controller, see
Controller" (page

Firewall protection

Both Windows XP Professional and Windows 2003 Server have built-in
firewalls.
By default, the firewall under Windows XP Professional does not allow
incoming access. However, the IP DECT Configurator can automatically
change the firewall settings. Verify the firewall settings after installation.
If a third-party firewall program is installed on your DAP Controller PC,
ensure the firewall does not block the ports used for the SIP DECT
system. By default, some ports are defined in IP DECT Configurator.
The ports defined by default:
•
From 3000 to 22229--multicast
•
From 28000 to 28017--DAP Controller services
•
30160--CDA services
If you change default ports in the IP DECT Configurator, ensure that the
firewall settings are updated correctly.

Internet information services

The DAP controller or manager runs as a service under Windows.
Because the management interface is available through a Web interface,
you must install the Web Server IIS.
"Firewall protection" (page
80).
102).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
80).
"Internet information services"
87).
"DHCP
"DAP