Nortel CS 1000 Manual page 248

248 Location builder tool
2
When the Location Builder initially loads, all fields are blank. The
preceding figure shows example data in the fields.
The main window contains the following component:
•
Use the Map pane to view a map of the area. There are two
view modes:
— Location view shows one whole floor with multiple
buildings visible.
— Building view shows a floor inside a building.
Switch between Location view and Building view by
double-clicking a building. You can select either a DAP, a
building, or a line.
Right-click the map to access menu commands to perform on
the selected item.
The Location Builder uses coordinates for the localization of
DAPs, buildings, and lines. The coordinates of the mouse
pointer appear if you hover the mouse pointer over the map.
The origin (0,0) of the coordinate system is in the bottom left
corner of the map.
•
Use the DAP list view mode pane to select the view mode
for the DAP list:
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.