Nortel CS 1000 Manual page 145

6 Click Save System and deactivate the system.
7 Ensure that DHCP and TFTP servers are configured properly, so
that DAPs can start in all Branch Offices.
8 Activate the system and restart all DAPs.
9 Start DAP Manager, open Access Points page and ensure that
all DAPs are present and working.
To create a Branch Office configuration, you must also perform the
following steps:
•
Perform configuration on Element Manager
To create a Branch Office configuration, you must add a location code
(for UDP) or trunk steering code (for CDP) for each Branch Office.
Perform one of the following:
—
Procedure 66 "Adding location code (for UDP)" (page 130)
OR
—
Procedure 67 "Adding Trunk Steering Code (CDP)" (page 130)
each Branch Office.
•
Perform configuration on NRS
To create a Branch Office Configuration, you must choose one DAP in
each Branch office as the DAP Redirect Server, and add a gateway
endpoint for this DAP in NRS and routing entry. Perform
"Adding Gateway Endpoint for DAP redirect server" (page
Procedure 76 "Configuring routing entries for DAP Redirect Server"
(page 137) for each Branch Office.
Record the location code or trunk steering code used as the routing
entry for each Branch Office (DAP Redirect Server). For instance, LOC
442 – DAP redirect server in Branch Office 1 LOC 443 – DAP redirect
server in Branch Office 2 or TSC 44 – DAP redirect server in Branch
Office 1 TSC 45 – DAP redirect server in Branch Office 2
•
Perform configuration on Call Server
To create a Branch Office Configuration, you must create a universal
extension block for each subscribed DN. For information, see
server configuration" (page
ATTENTION
When you configure key 1 hot P for a universal extension block (see
"Configuring Universal Extension" (page
steering code according the configuration you made in NRS. For example,
enter LOC 442 (or TSC 44) for handsets to be used in Branch Office 1, LOC
443 (or TSC 45) for handsets to be used in Branch Office 2.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Branch Office configuration 145
--End--
140).
140)), enter a location code or trunk
for
Procedure 75
136), and
"Call