Call Server Configuration - Nortel CS 1000 Manual

140 SIPN configuration
Call server configuration
You can configure the Call Server using a command line interface with
LD overlays.
Use LD 15 to enable Personal Call Assistant before you configure the
Personal Call Assistant.
Table 16
LD 15: Enable personal call assistant
Prompt Response
REQ CHG
TYPE FTR
n
CUST
...
PCA ON
...
Configuring Universal Extension
Universal Extension (UEXT) redirects incoming calls to the DAP. Key 0
corresponds with the DN configured on the DAP. Key 1 HOT P is the
same number with access and location codes (for UDP) or trunk steering
code (for CDP).
If you plan to create a Branch Office Configuration, see
configuration on Call Server" (page 145)
Use LD 11 to configure UEXT.
Ensure that packages 412 and 415 are enabled on the Call Server.
If you plan to configure Microsoft Office Communicator for your SIP
DECT handset, you must add the required settings to the UEXT block
(AST 0; CLS T87A). For the changes to take effect, you must save your
configuration using LD 43 and restart your system.
Table 17
LD 11: Add universal extension (UDP)
Prompt Response
REQ NEW
Wait until the operation is complete.
Description
FTR_DATA
n = customer number
Enable Personal Call Assistant
Description
Add new extension
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
--End--
"Perform
.