Nortel CS 1000 Manual page 139

Basic (simple) SIP DECT configuration with CS 1000 SIP Gateway 139
Configuring routing entries for the signaling server
If Collaborative servers are not configured on your system, you can
configure the default route for CDP for the Signalling Server instead of a
CDP routing entry.
Procedure 77
Configuring routing entries for the signaling server
Step Action
1 Select Numbering Plans > Routes.
2 In the Limit results to Domain fields, enter information for
existing service domain, UDP domain, and CDP domain.
3 In the Endpoint Name list, select the SIP endpoint for the
signaling server.
4 In Routing Entries (X), click Add.
5 Select Private level 0 regional (CDP location code) for DN
type, enter 0000-9999 for DN Prefix and 2 for Route cost.
ATTENTION
If you use a Trunk Steering Code (TSC) to make calls from CS 1000
to SIP DECT, the cost of the CDP routing entry for the Signaling
Server must be higher than the cost of the CDP routing entry for DAP
Redirect Server.
6 Click Save.
Saving changes
Save changes.
Procedure 78
Saving changes
Step Action
1 Click System > Database.
The Database page appears.
2 Click Cut over.
Wait until the operation is complete.
3 Click Commit.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
--End--