Nortel CS 1000 Manual page 77

2 Calculate the cell subdivisions as required.
Divide the number of users by the appropriate value (12 or 20)
shown in Table 14 "Cell reengineering" (page
result to the next whole number. The result equals the number
of cells required after subdividing the cell.
3 Divide the cell.
Draw lines from the cell center to the critical points on the cell
boundary. InFigure 33 "Example of a subdivided cell" (page
the cell 1C1 is divided into four sectors and cell 1C2 is divided
into three sectors.
4 Relocate new cell centers.
Mark new cell centers within the sectored areas.
5 Determine the number of handset users in the new cell areas.
6 Count the number of user offices within each smaller sector.
Ensure fewer user offices exist within the cell than the traffic
limit.
7 Take the deployment tool to the locations calculated on the floor
plan. Ensure that there is a location that meets the requirements
in "Deployment requirements" (page
8 Ensure the new cells have complete coverage.
9 Use the deployment handset to check coverage.
10 Repeat the anticipated handsets for each cell calculation
to ensure that each smaller cell provides appropriate traffic
coverage to the users in the area.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
System deployment 77
72). Round up the
18).
--End--
76),