48 Site planning and hardware deployment
Procedure 6
Locating the cell center
Step
1
2
3
Action
Place the deployment tool at one critical point and then use the
deployment handset to obtain a change in audio quality. The
audio quality change determines the cell boundary contour.
Repeat step 1 at an adjacent critical point. The call center is
where the cell boundaries of both critical points meet. Mark the
cell center position on a floor plan.
Use the cell contours to locate a cell center.
Locate the cell center where the cell contours meet. Choose a
position on the floor plan that meets the following requirements:
•
is farthest from the critical points
•
provides good audio quality at the critical point,
•
complies with the requirements described in section
"Deployment requirements" (page 18)
•
is in the coverage area
Label the cell center on the floor plan with the following symbol.
xCn, where x = the floor and n = is the cell number in sequence
of the entire plan.
In
Figure 19 "Example of a cell center" (page
center.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
49), IC1 is a cell
--End--