Types Of Sip Dect Configuration - Nortel CS 1000 Manual

28 Site planning and hardware deployment
Types of SIP DECT configuration
You can implement SIP DECT in various system configurations to
accommodate your needs. The most common SIP DECT configurations
are as follows:
•
Basic (or Simple) Configuration
•
Routed Head Quarter Configuration
•
Branch Office Configuration
•
Routed Head Quarter Configuration with Branch Office
•
Multi Site Mobility Network Configuration
•
Basic (or Simple) Configuration
In Basic Configuration all DAPs are in the same subnet that is
based on one or more IP switches. IP multicast must be able to
occur between all DAPs. The configuration supports seamless
handover between all DAPs. For an illustration of a simple SIP DECT
configuration, see
(page
Figure 5
Simple SIP DECT network configuration
•
Routed Head Quarter configuration
Routed Head Quarter Configuration is used for a Large Campus
network that is split into several subnets. In this configuration DAPs
belong to various subnets and behave as one large SIP DECT system
with the full support of seamless handover. IP multicast must be able
to occur between all DAPs in the Campus network, through IP switches
and the IP routers that connect the various subnets. For an illustration
Figure 5 "Simple SIP DECT network configuration"
28).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.