To Configure An Lsi Elite 1600 Raid System; Configuring Raid Using Lsi Elite 1600 Controller And Ctrl+M - Nortel CallPilot 703t Maintenance And Diagnostics

RAID operations
Configuring RAID using LSI Elite 1600
controller and Ctrl+M
The configuration of the RAID card is stored on both the card and on the
hard drive, so typically you are not required to reconfigure RAID unless
you are making a change to the RAID system (for example, if you
replace the hard drives with higher-capacity hard drives).
.
WARNING

To configure an LSI Elite 1600 RAID system

To configure RAID, do the following:
1 Turn on the server and press Ctrl+M when prompted during system
bootup.
Note: The Ctrl+M utility can take up to 1 minute to launch with 111U
firmware. The system may appear frozen. Do not reset.
2 From the Management menu, select Objects and press Enter.
176
CAUTION
Risk of data loss
This procedure requires that the logical drive be initialized.
When you initialize the logical drive, all data on the hard drives
is erased.
Do not perform this procedure unless you are replacing the
hard drives, or you are rebuilding the CallPilot system (that is,
reinstalling the Windows operating system and CallPilot
software).
Nortel strongly recommends that you not perform low
level formatting. Performing low level formatting results
in the drives becoming unusable.
Standard 1.06
CallPilot