Dap Controller - Nortel CS 1000 Manual

102 Software requirements
5
DAP configuration without DHCP or TFTP servers You can perform
DAP configuration without DHCP or TFTP servers using the Network
Settings window of the IP DECT Configurator.
Configure a DAP to store IP address and configuration data.
Procedure 41
Storing IP address and configuration data on a DAP
Step
1
2
3
4
5
6
7
8
9

DAP Controller

Perform the procedures in this section to install the DAP Controller from
the CD. You must execute this procedure only once, and thereafter use
the installation for any number of system configurations. You can change
settings later.
Click OK to save changes.
Action
Start the IP DECT Configurator and select Modify the system.
Select the system to modify.
Click More.
Select the DAP Boot Options check box.
Select Store IP configuration into flash memory.
Click Apply.
Click the Save system button in the left pane.
Ensure that the DHCP server is running and that the TFTP
server is running.
Restart the DAPs.
The IP data and configuration data is now stored into the DAPs
and the DAPs can function without the DHCP and TFTP servers.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
--End--
--End--