Call Server Configuration To Msmn - Nortel CS 1000 Manual

3 Click set standby DB view.
4 Select Routing Entries from the menu on the left.
5 Click Look Up.
The Look up path for gateway endpoints page appears.
Select the SIP endpoint for DAP on the current system, for
example, DAP1, and the ID of the selected endpoint is entered
in the Gateway Endpoint box.
6 Click Show to see all the entries for this endpoint.
This field is empty if no entries exist.
7 Click Add.
8 If you configured UDP, perform the following steps:
•
•
•
For example, enter 442????, for DN Prefix and 1 for Route cost.
9 Click Save.
10 If you configured CDP, select Private level 0 regional (CDP
location code) for DN type, enter the trunk steering code
(TSC) and question marks (?) equal to number of digits of DN
subscribed to DAP, for example, 44????, for DN Prefix and 1 for
Route cost and click Save.
11 Save changes.
ATTENTION
You must configure NRS on each system for MSMN. Location or
Trunk Steering codes must correspond with the codes configured on
each system.
Call server configuration to MSMN
In this document, the following parameters are used to show an example
of configuring an MSMN SIP DECT system.
•
Codes on system 1
—
Access Code: 9
—
Location code to DAP: 442
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Multi site mobility network configuration 153
Select Private level 1 regional (UDP location code) for DN
type.
Type the location code (LOC).
Type question marks (?) equal to the number of digits of DN
subscribed to DAP.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
--End--