Restarting A Dap; Restart All Daps - Nortel CS 1000 Manual

5 Enter the new RPN.
The RPN must be a hexadecimal two-digit number in the range
000 to 00F.
6 Click OK.
Wait until DAP restarts and starts working.

Restarting a DAP

Restart a DAP. This can be required if you are upgrading software, or if
a DAP is not functioning properly.
Procedure 114
Restarting a DAP
Step Action
1 Open Internet Explorer and enter the following URL in the
address field: localhost/cds.
The DAP manager IP DECT page appears.
2 Click Access points.
The DECT Access Points page appears.
3 Select the DAP to restart.
4 Click Reboot.
The DAP restarts. It takes several minutes for the DAP to begin
working again after it restarts.
ATTENTION
If you use Reboot to restart a DAP, information about types and
software versions of subscribed handsets is lost, and is restored after
several hours. You can restore this information immediately using
either of the following methods:
•
•

Restart all DAPs

Restart all the DAPs in a system. This can be required if you are
upgrading software, or if the DAPs are not functioning properly.
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Turn the handsets subscribed to the restarted DAP off, and
then on again.
Restart all DAPs using the option "Reboot all" in DAP
Manager. For information, see
201).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
DAP management 201
--End--
"Restart all DAPs" (page
--End--