Nortel CS 1000 Manual page 10

10 Product overview
A minimal SIP DECT system has the following main components.
•
Call Server
•
SIP Line Gateway or Signaling Server (according to configuration type)
•
PC with DAP controller software installed
•
DAP
•
handset
Use the following tools to configure SIP DECT.
•
Element manager or overlay program for Call Server
•
Element manager and, if required, Network Routing Service (NRS)
manager for Signaling Server
•
IP DECT Configurator—used to enter SIP DECT configuration
•
DAP Manager (IP DECT Manager)—a Web interface used for SIP
DECT administration tasks such as adding a handset or removing a
subscription.
The IP DECT Configurator and the DAP manager IP DECT are available
as a part of the DAP controller software package.
The following software releases are required for the main system
components:
•
Call Server, Release 6.0
•
Signaling Server, Release 6.0
•
DAP software 4910b427.dwl or later
•
DAP controller 4.2 or later (PC software)
You can connect IP phones to the TLAN, and you can connect TDM
phones to the Call Server, Voice Gateway Media Cards, and other
required cards in Call Server. Use Voice Gateway Media Cards for
IP-to-TDM calls and for conference calls involving IP phones or DECT
handsets on basestations. The configuration can also include a PC with
DECT Messenger to provide the DECT messaging service on SIP DECT.
For SIP DECT to function properly on SIPN configurations, you must install
a dedicated Signalling Server running the SIP Gateway application. You
can use other applications, such as H.323 Gateway, NRS, and IP Phones,
on the same Signaling Server without limitations.
Use the Dynamic Host Control Protocol (DHCP) server or the Trivial File
Transfer Protocol (TFTP) server unless you use a DAP configuration
without DHCP or TFTP. You can configure the system to use two separate
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.