Nortel CS 1000 Manual page 49

Figure 19
Example of a cell center
Mark the cell boundary.
Procedure 7
Demarcating a cell boundary
Step
1
2
3
4
5
Action
Set up the deployment tool basestation at the cell center.
Enter the site survey mode on the handset.
For more information, see
mode" (page 41) if you use Deployment Kit 2, or
149 "Entering the monitor mode" (page 270)
Deployment tool.
See the floor plan and check audio quality in user offices
within the cell. If a user office is in a zone where audio quality
deteriorates, relocate the cell center closer to the critical point or
the office.
Walk into all the areas (rooms) necessary to mark the complete
cell boundary. Radio signals travel further in uncluttered areas
than in cluttered areas. Record the cell boundary.
Find the cell boundary by measuring the range and marking it
on the floor plan with a small x. Repeat steps
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
System deployment 49
Procedure 1 "Entering the site survey
if you use an older
Step 3
Procedure
and Step