Dap Led Indications; Dap Firmware Update - Nortel CS 1000 Manual

Export DAP configuration information to a file by using the Web interface.
Procedure 129
Exporting DAP configuration information
Step
1
2
3
4
5
6

DAP LED indications

The DAP is equipped with one LED, which can indicate six DAP statuses:
•
Off: No power
•
On 0.5 seconds, off 0.5 seconds: Loading software/firmware.
•
DHCP or TFTP server; or no DAP Controller)
•
Fast blink: DAP is operational but trying to synchronize to another DAP
•
Continuous fast blink: Hardware error
•
Steady On: DAP operational (and synchronized to other DAP or is the
synchronization master)
DAP firmware update
Use the information in this section to load updated firmware to the DAPs.
Action
In an Internet browser, enter the DAP IP address in the address
field. For example: 192.168.32.108.
The General Settings page appears.
Click Save information in file
The File Download page appears.
Click Save.
Browse to the folder where you want to save the file.
Enter the name of the file, and click Save.
Optionally, click Home Page to return to the general settings
page.
Short flash every 0.25 seconds: IP Network error (not connected; no
CAUTION
Risk of service loss
You must update the firmware for all DAPs in the system at the
same time. Ensure that all DAPs are running, and can have
their firmware updated.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.

DAP firmware update 221

--End--