Nortel CS 1000 Manual page 88

88 Software requirements
You can create a DAP configuration without DHCP or TFTP; however
DHCP and TFTP must be available to program or reprogram DAPs. For
more information about DAP configuration without DHCP or TFTP, see
"DAP configuration without DHCP or TFTP servers" (page 102)
If you prefer to use Microsoft Windows DHCP and TFTP servers, perform
the steps in
DHCP server" (page 88)
the steps in
and configure TFTP servers.
If your DHCP server supports Vendor Class Identification option 60, use a
specific IP address range for the DAPs. The Vendor Class Identification of
the DAPs is D(ECT)AP 49.
Procedure 34
Installing and configuring Microsoft Windows DHCP server
Step
1
You can install the DHCP server on the same server on the same server
or on another PC that runs the TFTP server. The Microsoft DHCP server
(Windows 2000 / 2003) is in the Microsoft Windows 2000 / 2003 Server
CD-ROM package.
Procedure 34 "Installing and configuring Microsoft Windows
to install and configure DHCP servers. Perform
Procedure 37 "Installing the TFTP server" (page 95)
Action
Ensure that your DHCP server provides the following data to the
DAP.
•
IP Address
•
Subnet Mask
•
Default Gateway IP address
•
Next Boot Server IP address that is the IP address of the
TFTP server (DHCP option 066)
•
Configuration file name (dapcfg.txt) available through the
TFTP server (DHCP option 067)
You can install the DHCP server on the same server or on
another PC that runs the TFTP server.
The Microsoft DHCP server installation files are located on
the Microsoft Windows 2000/2003 Server CD-ROM package.
Licensing or registration charges or both may apply.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
--End--
.
to install