Sip Line Gateway Configuration; Call Server Configuration - Nortel CS 1000 Manual

6
SIP Line Gateway configuration
There are no specific SIP DECT configuration requirements for SIP LINE.
For information about installing and configuring SIP Line Gateway, see SIP
Line Fundamentals (NN43001-508).
When configuring SIP Line Gateway for use with a SIPL configuration,
ensure that you configure the following parameters:
•
While enabling the SIP Line Service and configuring the root domain,
enter a User agent DN prefix (which is required for UEXT SIPL
Configuration) and root domain name that are the same as the
values you entered for the SIP DECT domain name
"Configuring SIP Settings" (page
•
While Configuring SIP Line gateway node, enter the same domain
name as you entered for SIP DECT and SIP Line service, and ensure
that SIP LINE Gateway local SIP port corresponds with the Proxy port
configured for SIP DECT in
(page
for the SIP port in SIP DECT do not match, so you must change the
port for one of IP Line Gateway or SIP DECT configuration.
Call server configuration
You can configure the Call Server using a command line interface with
LD overlays.
Use LD 15 to enable Personal Call Assistant before you configure the
Personal Call Assistant.
Table 29
LD 15: Enable personal call assistant
Prompt Response
REQ CHG
Basic (simple) SIP DECT configuration with CS 1000 SIP Line Gateway 177
You must enter the PIN within 16 minutes, otherwise the
subscription mode terminates for that specific extension
number, and you must restart the subscription process from the
beginning.
Enter the name and DN of the SIP-DECT system.
The DN appears on the handset display. The status of the
subscription record changes from Enabled to Subscribed.
For information, see
163). The default values for SIP port in SIP Line Gateway and
Description
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
"Subscription management" (page
--End--
165).
Procedure 88 "Configuring IP Settings"
193).
Procedure 91