Routed Head Quarter Configuration - Nortel CS 1000 Manual

182 SIPL configuration
5
6
7
8
9
Routed Head Quarter configuration
In this configuration, there is more than one network segment in the
Head Quarter. The routers in this configuration must forward IP multicast
packages. Network components, such as switches and routers, must be
correctly configured for VoIP and IP multicast. The network must support
IP multicast between all network components used for IP DECT System.
You can edit the following settings:
•
Time to Live (TTL) value—The Time to Live value is used for the
multicast traffic. If the Time to Live for the multicast is set to 1,
multicast traffic is not forwarded by a Router. If the Time to Live is
greater than 1, multicast packages can be forwarded by the Router,
depending on settings in the Router. If the TTL (for the multicast
packages) is set to 1, leave this aggregated subnet mask empty. If the
TTL (for the multicast packages) is set to a value greater than 1, fill
in this aggregated subnet mask to signal to the system which smaller
subnets are connected as one subnet using a router supporting IP
multicast.
•
Aggregated Subnet mask—The aggregated subnet mask is the
subnet mask for the DAPs to determine the network boundaries for
•
RPN range - lowest RPN and highest RPN in this Branch
Office.
•
Subnet name – any name used to identify the Branch Office.
•
Time Offset - time zone for the current subnet (branch
office).
Perform one of the following steps:
If you were referred to this section from
"Configuring System Settings" (page
continue configuring the SIP DECT system using
"Configuring SIP Settings" (page
OR
Go to step 6.
Click Save System and deactivate the system.
Ensure that DHCP and TFTP servers are configured properly, so
that DAPs can start in all Branch Offices.
Activate the system and restart all DAPs.
Start DAP Manager, open Access Points page and ensure that
all DAPs are present and working.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
Procedure 90
165), click Apply and
Procedure 91
165).
--End--