Nortel CS 1000 Manual page 179

Prompt Response
TN L s c u, for
example, 96 0 1
0
UXTY SIPL
DES aaaa
SIPU xxxx
xxxx
NDID
xxxx
SCPW
KEY 0 aaa yyyy, for
example,
0 SCR 5001
1 HOT U yyyy,
for example,
1 HOT U 4425010
Configuring CLID
Before configuring CLID, create a CPND block.
You can configure CLID using LD 95.
Table 32
LD 95: Configure CLID
Prompt Response
REQ NEW
TYPE NAME
CUST n
DN xxxx, for example
5001
NAME aaaaaa, for
example
Nick Johns
Enabling message waiting indication
The following configuration in Customer Data Block must be presented to
enable Message Waiting Indication (MWI) for IP DECT handsets.
Package 175 must be enabled on the Call Server for this feature.
You can configure MWI using LD 15.
Basic (simple) SIP DECT configuration with CS 1000 SIP Line Gateway 179
Description
where L = virtual superloop, s = shelf,
c = card, u = unit
UEXT subtype
Designator. Optionally, enter a description.
SIP DECT user DN
SIP Line Node ID
password configured in DAP Controller
"Configuring SIP Settings" (page
0 aaa yyyy = Primary UEXT DN:
•
aaa = MCN, MCR, SCN, or SCR
•
yyyy = primary DN
1 hot u yyyy = Target DN:
•
yyyy = User Agent DN prefix (configured for SIP Line)+
subscribed DN on DAP
Description
n = customer number
DN configured at the DAP and UEXT Key 0 at DN.
Handset user name
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
(Procedure 91
165)).