Nortel CS 1000 Manual page 118

Sip dect fundamentals
Hide thumbs Also See for CS 1000:
Table of Contents

Advertisement

118 SIPN configuration
8
9
10
11
12
13
14
15
16
Click More >> to access Advanced Email Settings.
In Advanced Email Settings, enter a value next to SMTP
Server with the DNS name or the IP address of your SMTP mail
server.
With Advanced Email Settings, email messages can be sent
automatically if a DAP fails or if the channel occupation threshold
is exceeded for more than a specified number of seconds.
Automatic email messages can be sent only if the DAP controller
or manager is running, and the PCR service is running on the
DAP controller or manager PC.
If you enter the DNS name of your SMTP Server, ensure that
the DNS server address is configured for the network connection
on the DAP Controller.
Select the Send alarm emails check box , which enables SIP
DECT to send email messages to the SMTP Server.
Fill the field next to Email addresses: with one or more
destination email addresses.
Enter a value next to Email from: with the email address of the
originator.
Normally, the SMTP server does not verify the email address of
the originator. This means you can enter any email address in
this field.
Fill in the two boxes after Channel Occupation. In the
Threshold box, specify the percentage. In the Time box, specify
a time in seconds.
Channel Occupation defines the conditions for generating an
email on DAP channel occupation. If the channel occupation
is higher than the percentage of the available channels for a
specified time period, an email is generated. The threshold is
specified in percentage, the time is specified in seconds.
Fill in the box next to Alarm reaction time with an amount of
time in hours as an interval for sending email messages.
The default Alarm reaction time is 24 hours. This means that
the minimum interval between two alarm email messages is 24
hours; after the system sends an alarm email, 24 hours must
pass before the system can send out another alarm email.
Enter 0 (zero) if you want alarm email messages to be sent
immediately after an alarm event occurs.
Select the Email nightly created archive check box , which lets
you automatically receive archives for each email.
Enter a value next to Email addresses with one or more
destination email addresses.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.

Advertisement

Table of Contents
loading

Table of Contents