Branch Office Configuration - Nortel CS 1000 Manual

180 SIPL configuration
Table 33
LD 15: Enable message waiting indication
Prompt Response
REQ CHG
TYPE IMS
n
CUST
...
IMS YES
...
Table 34
LD 15: Enable Message Center
Prompt Response
REQ CHG
TYPE FTR
n
CUST
...
OPT MCI
...
Branch Office configuration
Use Branch Office Configuration for a Large Campus network that is split
up into various (geographical) segments (branch offices), so that every
branch office has its own subnet and DAPs can exchange IP multicast
packets only using routers or switches in the subnet of their local branch
office. No IP multicast traffic is allowed between branch offices. In this
configuration each branch office behaves as an isolated part of a larger
SIP DECT system. Branch Office configuration supports seamless
handover within each branch office, but not between sites. Support is
unavailable for roaming between branch offices.
To configure Branch Office, see
with CS 1000 SIP Line Gateway" (page
section when you require information about Branch Office configuration.
Select a Branch Office configuration.
Procedure 101
Selecting a system configuration
Description
IMS_DATA
n = customer number
Enable IMS
Description
FTR_DATA
n = customer number
Message Center included
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
"Basic (simple) SIP DECT configuration
159). Use the information in this