Charging The Deployment Tool Battery - Nortel CS 1000 Manual

•
"Assembling the deployment tool" (page 267)
•
"Testing the deployment handset" (page 270)

Charging the deployment tool battery

Charge the deployment tool battery for at least six hours before using.
The deployment tool charger has the following components:
•
battery charger (must be ordered separately)
•
battery charger cable
The following figure shows the charger for the deployment tool.
Figure 39
Deployment tool battery charger
Procedure 146
Charging the deployment tool battery
Step Action
1 Set up the deployment tool battery charging equipment.
Remove the deployment tool battery, charger, and charger cord
from the yellow case.
2 Charge the deployment tool battery.
Connect the charger cord plug into the battery. Connect the red
alligator clip to the positive lead of the charger and the black clip
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
CAUTION
Equipment Damage
Use the Nortel battery charger. This charger is a separately
ordered item. Failure to use an automatic shutoff battery
charger can damage the battery.
Do not use the battery supplied with the CT2 deployment tool.
The CT2 and DECT batteries are not interchangeable.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Prepare the tool for deployment 265