Nortel CS 1000 Manual page 98

98 Software requirements
Prerequisites If you are configuring a new system, perform the following
procedures before your configure the built-in DHCP server.
•
Procedure 43 "Starting the IP DECT Configurator" (page 109)
•
Procedure 44 "Adding a new system using the IP DECT Configurator"
(page 109)
Procedure 39
Configuring the built-in DHCP server using the IP DECT Configurator
Network Settings Window
Step
1
2
3
4
5
6
7
8
9
10
11
Action
Start the IP DECT Configurator, and select Modify the system.
Choose the system to modify.
Select the Run DHCP server on this PC check box.
Enter the DAP IP range, for example, 192.168.100.200-210.
Select the DAP IP Range exclusive for DAPs only.
Enter the Subnet Mask, for example, 255.255.255.0.
Enter the Default gateway, for example, 192.168.100.1.
Enter the TFTP IP address on the PC where the DAP controller
software is installed, for example, 192.168.100.10.
If you must assign manually IP addresses to the DAP, click
More.
Enter MAC address of the DAP and the IP address assigned
to the DAP.
You can add DAPs to the list, delete DAPs from the list, or edit
the addresses.
Click Apply to save the changes, or Close to exit.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.