Dap Controller Deactivation - Nortel CS 1000 Manual

DAP Controller deactivation

You can use the DAP Controller to configure the SIP DECT system. In
addition, if the DAP Controller is connected and active, it can perform the
following functions:
•
Process messaging (Low Rate Messaging and interaction with DECT
Messenger).
•
Move subscriptions from a nonworking DAP to a working DAP.
You can configure the number of minutes for which a DAP must be
unavailable before the system considers it to be not working; the
default is 10 minutes.
•
Monitor the SIP DECT system and send archives and alarms by email.
•
Provide the built-in DHCP and TFTP servers.
After you configure the SIP DECT system using the DAP Controller, you
can perform either of the following:
•
Leave the DAP Controller PC connected and active, so that it performs
all the functions in the preceding list, and you can use it at any time to
configure the SIP DECT system.
•
Deactivate the DAP Controller software. You can then use the DAP
Controller PC for other purposes, and optionally disconnect it from the
network. You can reactivate the DAP Controller software at any time to
configure the SIP DECT system.
If you disconnect your DAP controller PC from the network, you must first
deactivate SIP DECT services.
Procedure 136
Deactivating SIP DECT services
Step
1
2
3
ATTENTION
If you use the built-in DHCP and TFTP servers, do not deactivate the DAP
Controller software. In this case, deactivating the DAP Controller software
can interrupt service when a DAP restarts, for instance during a power
interruption or during a firmware upgrade.
Action
Start DAP Configurator
In the IP DECT Configurator main window, click Activate/Deac
tivate/System Status.
Click Deactivate All (indicated in the following figure) to stop all
enabled services and programs.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
DAP Controller deactivation 235