Nortel CS 1000 Manual page 104

Sip dect fundamentals
Hide thumbs Also See for CS 1000:
Table of Contents

Advertisement

104 Software requirements
6
7
8
9
10
11
A message appears requesting that you restart the PC.
Click OK to restart the PC.
After the PC restarts, it automatically continues with the DAP
controller installation. The DAP controller - InstallShield
Wizard page appears.
Click Next.
The System Type page appears.
Two types of DAP Controller installation are available. Select
one of the following:
Select Single System if plan to manage only one SIP DECT
system with your PC. Nortel recommends this option unless
you install DAP Controller on a laptop PC to be carried
between SIP DECT systems, to manage them.
OR
Select Multiple Systems to manage more than one SIP
DECT system with your PC. This option is meaningful for
a laptop PC to be carried from one SIP DECT system to
another to configure and maintain them. You can select
this option when installing a DAP Controller dedicated to a
specific SIP DECT system, in such a case the DAP Controller
operates as it would in Single System mode.
You cannot use DAP Controller PC in more than one system at
the same time. With a Multiple Systems installation type, you
can activate one of the configured SIP DECT systems and make
changes.
The DAP Controller PC can work with only one active SIP DECT
system. Nortel recommends that you configure a dedicated DAP
Controller PC in each SIP DECT system. If you cannot dedicate
a DAP Controller PC in each SIP DECT system, then you can
use a laptop PC with DAP Controller installed and temporarily
connect that laptop PC to the networks where each SIP DECT
system is installed (the option Multiple Systems exists to support
that configuration). Some functions of SIP DECT system are not
available when no dedicated DAP Controller PC is available in
the system.
Click Next.
The Setup Type page appears.
Select Standard, and click Next. To customize the installation,
select Custom.
Click Next. The Select Installation Address page appears.
Do not change the default values in the fields CDS and Port
Number.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.

Advertisement

Table of Contents
loading

Table of Contents