1/10Gb Lan Switch Module - Hitachi CB 520H B1 Service Manual

No.
4 Reset switch (RST)
5 Power LED (PWR)
6 Status1 LED (ST1)
7 Identify LED (LOCID)

1/10Gb LAN switch module

Table 1-36 LEDs and connectors on 1/10Gb LAN switch module
No.
1 LAN ports 1 to 4
2 10GBASE-R slots
3 Memory Card slot (MC) -
4 Access LED (ACC)
5 Reset switch (RST)
6 TX/RX LED for XFP
7 LINK LED for XFP
Name
-
Green-On
Green-On
Green-Blink Power-on diagnosis or software activation.
Red-Blink
Red-On
Blue-On
Figure 1-44 1/10Gb LAN switch module
Name
Green-On
Green-Blink Link activity. Port is sending or receiving data.
Amber-On
-
Green-On
-
Green-On
Off
Green-On
Introduction
Hitachi Compute Blade 500 Series System Service Manual
State
Press and hold for five seconds to reset the
LAN switch module.
Powered-on, normal operation.
Normal operation.
Fault. Maximum temperature limit exceeded
or other warning.
Alarm.
The switch module is identified.
State
Link is established
Link failed.
Slots for 10GBASE-LR or 10GBASE-SR
transceiver: Each slot has a link LED on the
upper right and a TX/RX LED on the lower
right.
Slot for SD memory card.
The SD memory card is accessed
Press and hold it for about five seconds or
more, reset the module.
A link is established on 10BASE-R and the
port is sending or receiving data.
The port is neither sending nor receiving data.
A link is established on 10BASE-R.
Description
Description
1-33